anko 43158447 12v Portable Food Warmer User Manual
Please read all the information carefully before you use the product and retain it for future use.
Caution:
- Do not use while driving
- Keep out of reach of children
- This unit must never be submerged in liquids
- Do not touch the hot surface of the unit
- Do not heat food in plastic bags
- Do not heat food in sealed containers
- Do not use any type of plastic containers
- Unplug the unit when not in use
- Allow unit to cool before storing
- Do not clean surface with scouring pads
- Take Caution as the unit gets very hot very quickly and stays hot for some time after use
- Do not immerse cord or the unit in any liquid
- The unit may produce steam from seals which can burn
- Keep a safe distance when in use
- Open the unit carefully with face and skin away or protected
- Do not place on any surface that can be damaged by heat
PRODUCT SPEC
Maximum Capacity: 2.8 Liters
Power Source: 12V DC
Max Wattage: 144 watts
Maximum Amperage Draw: 12 Amp
Fuse: 15 Amp
Temperature Up to:120℃
Material: PPF, Aluminum
Power Cord: 180 cm
Dimensions: 20 x 27 x 18cm
This unit operates with a 12V vehicle system. Always start your vehicle engine before plugging in your portable food warmer. This unit draws up to 12 Amp during operation, so make sure that the circuit you are using is rated for this much current. Average current draw is about 5 Amps.
The power cord may have a fuse installed in the plug. If required, replace the fuse with a new one of the same amp rating (A) only.
OPERATING INSTRUCTIONS
Internal temperature can reach to 120℃. Puncture cans and open the jars before heating.
Place food in aluminum foil or small oven bags to make cleanup easier. You can safely put food in an aluminum pan.
A water bath helps to spread the heat more quickly when cooking food in their original containers.
Water must never be added when the unit is hot.
APPROXIMATE HEATING TIMES
NOTE: Heating food improves with increased contact with bottom pan; a water bath helps. Small oven bags or aluminum foil can be used as well.
CLEAN UP
ALWAYS UNPLUG THE UNIT BEFORE CLEANING
DO NOT IMMERSE UNIT IN ANY LIQUID.
Use a cloth, soft brush or sponge with water and a mild dish soap.
Do not use metal scouring pads.
TROUBLESHOOTING:
This unit is equipped with a 15A fuse. Check fuse panel before connecting. If it does not operate:
- Make sure that all contacts in the socket are clean
- Ensure that the plug is securely plugged into the power source.
- Check the fuse on the power cable.
If blown, replace with a new 15A fuse. - Check the fuse panel in the vehicle to make sure that the fuse controlling the socket is intact. It might be necessary to replace it with a new 15A fuse.