Vibe EB030 True Wireless Earbuds Guide

by 
Vibe EB030 True Wireless Earbuds Guide

Vibe EB030 True Wireless Earbuds User Guide

CHARGING THE EARBUDS

Vibe EB030 True Wireless Earbuds User Guide - Charging the Earbuds Vibe EB030 True Wireless Earbuds User Guide - Charging the Earbuds

USING EARBUDS FOR DIFFERENT DEVICES

Your earbuds will work best if it is within 30 ft. of your smart device. You may experience the sound briefly cutting off if you are out of range or if your wireless connection is weak. If the earbuds are not paired with a device after 2 minutes, it will turn off automatically.

Vibe EB030 True Wireless Earbuds User Guide - Using Earbuds for Different Devices Vibe EB030 True Wireless Earbuds User Guide - Using Earbuds for Different Devices

USING EARBUDS AS A PAIR

The earbuds can be paired to different devices. For example, you can use one earbud with a smart phone and the other earbud for a tablet.

Vibe EB030 True Wireless Earbuds User Guide - Using Earbuds as a Pair

MUSIC CONTROLS

  • Press the button once to pause your music.
  • Press the left button three to skip to the previous track.
  • Press the right button three to skip to the next track.
  • Volume control is only through your smart phone or wireless device.

USING YOUR EARBUDS FOR CALLS

  • Press the button once to answer or end call.
  • Press the button twice is to redial lost call.

CONNECTION LOST?

  • If pairing two earbuds does not work, turn oft the earbuds and repeat the steps again in “Using earbuds as a pair”.
  • Make sure your earbuds are within range of your smart device.
  • If you hear o long beep, you need to recharge your earbuds.
    Connection may be lost due to low battery.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction