RiTTO RGE2057101 TwinBus IP REG Bus Filter Installation

RiTTO RGE2057101 TwinBus IP REG Bus Filter Installation

Table of Contents

For your safety

DANGER
⚠ HAZARD OF ELECTRIC SHOCK, OR ARC FLASH
Safe electrical installation must be carried out only by skilled professionals. Skilled professionals must prove profound knowledge in the following areas:

Connecting to installation networks
Connecting several electrical devices
Laying electric cables
Safety standards, local wiring rules and regulations

Failure to follow these instructions will result in death or serious injury.

About this document

In this document you will find all information for safe installation.
For further product information, follow the QR Code.

https://www.merten.de/profibereich/service/downloads.html

Scope of supply

REG Bus Filter, installation guide

Introduction to the Twin Bus IP REG Bus Filter

The Twin Bus IP REG Bus Filter (hereinafter referred to as the bus filter) is designed for isolating the power supply from the bus.

Device overview

A Port In A Bus +, In
B Bus B LED green
C Port Out A Bus +, Out B Bus
D Disassembly clip
The green LED indicates that the supply voltage from the REG power supply is present.

The right place to install

The bus filter is mounted on a TH 35/7.5 or TH 35/15 standard DIN rail. When choosing the installation location, the maximum cable length must be observed. The following table shows the maximum cable length between the bus filter and the system. components.

Installation

⚠ WARNING DANGER TO LIFE DUE TO ELECTRIC SHOCK

Only mount devices with basic insulation next to the device.

Failure to comply with this instruction may result in death or serious injury.

Technical data

WEEE

Dispose of the device separately from household waste at an official collection point. Professional recycling protects people and the environment against potential negative effects.

Schneider Electric GmbH c/o Ritto

Gothaer Straße 29, 40880 Ratingen