naturaled NAT-9567 LED Flood Light Adjustable Wattage Installation
⚠ WARNING
To reduce the risk of electrical shock, fire, or injury to persons; read and follow all warnings and installation instructions before installing. All installation should be
performed by a qualified electrician.
Risk of Electric Shock
Ensure power is off before installation or inspection. All wirings are performed in accordance with Electrical Code and local electrical code.
Risk of Fire
Fixtures are rated for use in 120-277V, 50-60Hz protected circuit and 90°C rated supply wire.
FORYOUR SAFETY
While performing installations described, gloves, safety glasses or goggles should be worn.
Any alteration or modification of this product is expressly forbidden as it may cause serious personal injury, death, property damage and/or product malfunction.
To prevent product malfunction and/or electrical shock, this product must be properly grounded
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
Do not alter, relocate, or remove wiring, lamp holders, power supply, or any other electrical component.
SUITABLE FORWET LOCATIONS.
Plusrite USA
2000 S. Grove Ave, Bldg B
Ontario CA 91761
T: 909-930-6868
T: 888-758-7443
F: 909-930-9988
www.naturaled.com
LED Flood Light
INSTALLATION
Disconnect the power before installation. Exploded view of completed assembly with component call out. 1, 2, 3, etc.
Step of adjusting wattage
Step 1: Turn the light-emitting side of the lamp downward and twist out the plug with a cross screwdriver;
Step 2 :Take out the plug and put it aside temporarily;
Step 3 : Set power switch to the corresponding position as required;
Step 4 : Screw the plug back into the power supply cover plate
with a screwdriver.
Installation – Kunckle Mount
Installation – Yoke Mount
