Thank you for choosing Mi Bedside Lamp. High-quality LED lights and professional optical structure combined with the natural light mixing algorithm make Mi Bedside Lamp a perfect companion to your bedside table.
Instruction
Unpack the lamp and connect the power cord.
* Place the lamp on a bedside table.
Install Mi Home App
1. Scan the QR code below or go to App store to and install Mi Home app.
2. Turn on the lamp, open the app, and follow instructions.
* Make sure that the Wi-Fi network is available and is
able to access the Internet properly.
Advanced features
Delayed power off
Hold the power buon until the light starts breathing, then release.
* The lamp will switch off in 15 minutes by default. You can adjust the delay in the Mi Home app.
Adjusting colors
Slide along the edge while holding the preset buon to adjust colors.
* This action does not change the color presets.
Factory reset
Press and hold the power buon and the preset buon simultaneously for 5 seconds. The light will turn red, green, and blue; and the lamp will reboot aer that.
Perform the factory reset and connect the lamp again every time you use a new Wi-Fi network.
FCC Compliance Statement
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
Warning
Features
Specifications
Model: MJCTD01YL
Luminous flux: 300 lumens
Color temperature range: 1700-6500 K
Color range: 16 million colors
Life expectancy: 25,000 h
Frequency bands: 2402-2480 MHz
Controls: touch, soware
Power factor: 0.5
Rated lamp input: 12 V 1 A
Rated input: 100-240 V~50/60 Hz 0.45 A
Rated power: 10 W (14×0.7 W/LED module)
Maximum output power: 10 W
System requirements: Android 4.4 or iOS 8.0 or later versions
Connectivity: Wi-Fi IEEE 802.11 b/g/n 2.4 GHz, Bluetooth 4.2 BLE
FCC ID: 2ABEU-MJCTD01YL
Read this manual carefully before using the product
Go to www.mi.com to learn more.
Manufacturer: Qingdao Yeelink Information Technology Co., Ltd. (a Mi Ecosystem Company)
Address: 10F-B4, Building B, International Innovation Park, 1 Keyuan Weiyi Road, Laoshan, Qingdao, Shandong Province, China