luminii LL36X2 LineLED 24V LED Strip Light Instruction Manual
info@luminii.com
www.luminii.com
- Product should be installed by a qualified electrician.
- Prior to installation ensure power is off at fuse box to prevent electrical shock.
- Use only with Class 2 power unit. Utiliser seulement avec Classe 2 unite d’alimentation electrique.
- Suitable for Damp Locations. Convient Aux Emplacements Humides.
- For under-cabinet or shelf mount.
- Conforms to UL STD 2108. Certified to CSA STD C22.2 No.250.0.
Attention: Always test Line LED operation before installing.
Connect Line LED to power supply to ensure it is working properly and no damage has occured during shipping.
1) Clean the area thoroughly where the Line LED will be installed.
Remove the paper backing from the Line LED and firmly press down making sure there are no air bubbles that can cause surface irregularities. Do not remove the adhesive, removing the adhesive may cause arcing of the Line LED tape.
2)
3) RECOMMENDED LAYOUT FOR MULTIPLE ADJACENT RUNS OF LINELED FED WITH SEPARATE POWER SUPPLIES
Position power supplies either in the middle of two runs or at the opposite ends.
4) Always ensure power to power supply is off! Follow diagrams to connect power feed wires to power supply. Refer to power supply instructions for wiring line voltage side.
Connect positive wire (plus sign tag or red wire) to RED low voltage wire from power supply. Also, connect negative wire (no tag or black wire) to BLACK low voltage wire from power supply.
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATIONS WITHOUT NOTICE
REV1.5 24082022