LEDVANCE 4058075478312 Smart Plus Wifi Flood Camera User Manual
OPTIONAL
https://www.ledvance.com/consumer/smart/faq/
Hereby, LEDVANCE GmbH declares that the radio equipment type LEDVANCE SMART+ Device is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: smartplus.ledvance.com/declaration-of-conformity. Wireless radio used in WIFI lamps/ luminaires /components 2412–2483.5 MHz, max. RF output power 16dBm
HOW TO USE
LIGHT SETTINGS
Time settings
- The time (switch-off delay) can be set from 5s – 360s
- Every detected movement re-activates the light
Twilight settings
The brightness response threshold (twilight) can be infinitely varied from approx. 10 – 500lux
Factory settings
- Time setting: 120s
- Twilight setting: 40lux
AIMING FLOODLIGHT HEAD
The Floodlight head can be adjusted
- Up/down 180°
- Left/right 150°
CAMERA FUNCTION
- The camera films a sequence when the sensor is triggered
- The filmed sequence is saved on the memory card or cloud storage and can be retrieved at any time
- The recorded data is saved on the unit‘s memory card or cloud storage
- A QR code is generated on the smartphone or tablet which can be read by another smartphone or tablet
- Once the sensor has been triggered, the user receives a push notification via the LEDVANCE App (can be deactivated)
– Open LEDVANCE App
– Use image display and intercom system
– Switch between HD and SD mode possible
– If HD image shows delay, SD is recommended
AIMING CAMERA
The camera can be adjusted
- Up/down 40°
- Left/right 355°
ALARM FUNCTION
– Acoustic alarm signal reacting on detected movement
– Sensor sensitivity can be adjusted (low, medium, high)
FOUR SECURITY MODES
Low level:
- System default lighting environment: 40lux
- Sensor distance: 5m
- Lumen: 400lm
- Lighting time: 60s
Middle level:
- System default lighting environment: 40lux
- Sensor distance: 8m
- Lumen: 800lm
- Lighting time: 120s
High level:
- System default lighting environment: 40lux
- Sensor distance: 12m
- Lumen: 1800lm
- Lighting time: 360s
Custom mode:
The default of custom mode is the same as Low mode. You can adjust the data to your preferences.
Further information on the functions and setting options can be found in the LEDVANCE App.
INSERT SD MEMORY CARD
– Undo retaining screw and remove cover
– Insert SD memory card
– Fit cover and tighten retaining screw
RESTORING FACTORY SETTINGS
– Undo retaining screw and remove cover
– Using the needle, press reset button for approx. 7s until the signal sounds
While resetting:
Status LED lights up green
- Flashes fast
After resetting:
Acoustic signal one time Status LED flashes green
- Flashes slowly
– Open LEDVANCE App
– Clear camera in LEDVANCE App
– Re-configure unit
– Fit cover and tighten retaining screw
https://eprel.ec.europa.eu/qr/583885
G11128838
30.09.2021
LEDVANCE GmbH
Steinerne Furt 62
86167 Augsburg, Germany
www.ledvance.com