integral LED ILNLMS-CL-BAT Night Light Motion Sensor Instruction Manual
Night light motion sensor with batteries
Thank you for purchasing an INTEGRAL LED product. When installed correctly this unit will provide years of service. For support or warranty information, please see integral-led.com.
Installation Instructions
Install the batteries (3 X AAA). (Fig. 1) The product can be freestanding or wall-mounted (ideally in a reflective area). (Fig. 2/3) Check the electrical and plumbing locations before drilling. You may need to use different fittings depending on your wall type. Seek professional advice if in doubt. Test the position first before wall mounting. The light comes on in the dark when motion is detected within three metres. It stays on for 30 seconds or until no motion is detected. A red light indicates low battery power. (Fig. 4)
WASTE ELECTRICAL PRODUCTS SHOULD NOT BE DISPOSED OF WITH HOUSEHOLD WASTE. PLEASE RECYCLE WHERE FACILITIES EXIST. CHECK WITH YOUR LOCAL AUTHORITY FOR RECYCLING ADVICE.
Warranty/Technical & contact information are all available at www.integral-led.com
Integral LED is a division of Integral Memory plc:
Unit 6, Iron Bridge Close, Iron Bridge Business Park, London, NW10 0UF, UK Integral Europe BV, 2801 DG, NL