idinio 0140148 Smart Ceiling Light User Manual
⚠ Your tablet or smartphone must be connected to a 2.4GHz WiFi network
Installation
Download the ldinio Smart app from the Google Play or Apple App Store and create a user account.
⚠ Basic network requirements
This device only supports ZAGHz WiFi networks so when you own a 5GHz router you must select the 2.4GHz network or disable the 5GHz network first in your router menu. Refer to your router manual for instructions.
Make sure that during the pairing process this device as well as your iOS or Android device will remain in the WiFi range of your router.
⚠ Replace LED module by qualified personnel only
Add device
AP Made
If adding the device failed, it may be a networking problem. You can now proceed using the AP Mode for adding the device.
The bulb must blink slowly. If this is rot the case you mu~ reset the device by tuning the bulb on/off/on/off/on/off/on
Press’+’ and select ‘Lighting’ and choose the right luminaire.
Tap ‘Other Mode’ in the top right corner and select ‘AP Mode’,
Check if the connection light is flashing slowly. Press ‘Confirm indicator slowly blinks’, Then select your 2.4GHz network, password and confirm.
Connect you smartphone or tablet with the device’s hotspot Tap ‘Connect’. The app will now open the settings menu of your smartphone or tablet Open WiFi settings.
Search the smart device name in the list of WiFi networks and connect Devices will connect with each other.
Now open the ldinio Smart app again and wait until the connection process is finished.
Wait until the connection is successful.
⚠ WARNING
⚠ Safety Warning!
Ensure you have fully read and understood the instructions in this document before you install or use the product following the installation/wire diagram (when applicable Keep this document for future reference and only use the product as described in this document Any other use of the product than described in this manual may damage the product or cause injury to the user (e.g. due to a short circuit. fire or electric shoe kl Disconnect the product from the power source if problems occur. Do not drop the product and avoid bumping. Do not use the product if a part is damaged or defective. Replace a damaged defective product immediately. When a non-standard consumer (power) Installation is required this should be performed by a qualified technician to reduce the risk of an electric shock. Make sure the product is sufficiently ventilated during use. Never cover an electrical (LED)device during usage since it can generate heat causing damage. Besides LED can be extremely bright and may cause serious eye damage so don’t stare at it directly. When a product is meant for indoor and/or outdoor use only. this will be mentioned on the product/parts or in the manual. Keep the product out of reach of children or animals.
Cleaning and Maintenance warning!
Do not use cleaning solvents or abrasives. Do not clean the inside of the device. Do not attempt to repair the device when the device does not operate correctly. replace it Clean the outside of the device using a soft. damp cloth (don’t use microfiber cloth)
Support
If you need further help or have comments or suggestions please visit www.shada.nl/nl/contact
D.O.C.: shada.nl/140148
Molenmakershoek28, NL-7328JKAPELDOORN -The Netherlands www.shada.nl
