DURATECH PL-REM-200 Link Driver User Manual

DURATECH PL-REM-200 Link 
Driver User Manual

Table of Contents

Technical specifications

Electrical specifications

General specifications Controller

Box contents

PL-REM-200 controller
Handheld transmitter (DuraLink™ version)
Spare battery (type A23 12V)
Screws (4x) & wall plugs (4x)
Owners’s manual

Installation instructions

Connect a 230VAC power source to the “220-240VAC INPUT” terminal
Connect the swimming pool lights to the “Lamp 12VAC output” terminal

Make sure the total load of pool lights does not exceed 200Watt

Optional: The “Switch A” & “switch B” terminals can be used to control auxiliary circuits like a pool cover or garden lights.

Pairing handheld transmitter & controller

The handheld transmitter is already paired in the factory and ready to use. The PL-REM-200 can pair with up to 6 handheld transmitters. In case a problem arises, the pairing process can be done manually:

Manual Pairing process:

Make sure the PL-REM-200 is connected to a power source.

Press the pairing button on the small circuit board, inside the controller for at least 5 seconds.
–> The LED will start to blink fast
Within 25 seconds, press any button on the handheld transmitter.
–> If the transmitter is paired correctly, the LED will flash slowly for 5 times
–> If the PL-REM-200 pairing memory is full, the LED will flash 15 times.
This means 6 handheld devices have already been paired.

To unpair all handheld transmitters with the controller: Push the pairing button for at least 5 seconds, then do nothing for at least 25 seconds.

–> The pair memory will be erased – the green LED will flash 5x on/off.

If no transmitters are paired, the PL-REM-200 will accept messages from any transmitter!