devolo Giga Bridge Installation Manual
Installation videos / Manual
www.devolo.global/giga-bridge-install
Using the coax or phone lines for a high-speed network at home
The devolo Giga Bridge is intended solely for use on cleared exclusively available telephone or coaxial cables. The free availability of the lines without third-party devices must be determined before connecting the devolo Giga Bridge.
Pairing of devolo Giga Bridges
If you have purchased a single adapter to expand your existing network, start the installation with page 9. Otherwise, connect both devolo Giga Bridge adapters to an available power socket. The LEDs of both adapters flash white. Carry out the next installation step within 3 minutes.
Connect the two devolo Giga Bridge adapters to the phone sockets using the network cable supplied. A new devolo Giga Bridge network is automatically set up (pairing). When both LEDs light up white continuously, the process is complete and you can remove the network cable again.
Pairing of additional adapters
If you want to integrate an additional adapter into your network, plug the additional adapter into a socket next to an adapter that has already been paired. Connect both adapters with the network cable supplied via the phone socket. Press the button on the right edge of the already installed adapter within 2 minutes. The LEDs of both adapters flash white.
The new adapter is automatically integrated into the devolo Giga Bridge network (pairing). Pairing is complete as soon as the LEDs of both adapters light up white continuously. You can remove the network cable and plug in the adapters where you want to use them. Go to p. 17 (Phone) or p. 21 (Coax).
The devolo Giga Bridge uses G.hn technology for the transmission of the Internet signal over coaxial (TV/SAT) or telephone line. In scenario “a” (as of p. 15), the G.hn signal is transmitted over two telephone wires or in scenario “b” (as of p. 19) via standard coaxial cable.
Telephone cabling
Connect the devolo Giga Bridge adapter to a LAN port (Local Area Network) of the router using the provided network cable. Connect the devolo Giga Bridge (phone socket) to the telephone wall socket using the provided telephone cable.
Now place the additional Giga Bridge adapter(s) in the preferred rooms. Connect the devolo Giga Bridge adapter to the wall connection using the provided telephone cable. You can then connect your end devices or Wi-Fi access points via an Ethernet cable. Done.
Coaxial cabling
Connect the devolo Giga Bridge adapter to a LAN port (Local Area Network) of the router using the provided network cable. Connect the devolo Giga Bridge (Coax socket) to the wall socket using the provided coaxial cable.
Now place the additional Giga Bridge adapter(s) in the preferred rooms. Connect the devolo Giga Bridge adapter (Coax socket) to the wall connection using the provided coaxial cable. You can then connect your end devices or Wi-Fi access points via an Ethernet cable. Done.
* In the manual you will see how to carry out manual pairing.
Support
Warranty: 3 years If your devolo device is found to be defective during initial installation or within the warranty period, please contact the vendor who sold you the product. The vendor will take care of the repair or warranty claim for you. The complete warranty conditions can be found at www.devolo.global/warranty.
