PRODUCT FEATURES:
– Replaces factory tailgate handle assembly.
– Selectable Parking Guide Line ON or OFF.
– Maintains the OEM look.
PARTS INCLUDED:
- Tailgate handle camera
- 26 ft. extension cable
INSTALLATION INSTRUCTIONS:
- Remove the factory tailgate handle and remove the emblem and key cylinder.
- Run the camera cable to the inside of the cabin towards the radio.
- Make the power and video connections to the rear view camera integration interface or the aftermarket radio or the reverse light.
- Install the emblem and key cylinder to the CNS-02F tailgate handle assembly.
- Test the camera for functionality. Decide whether the parking guide line will be used or not. See below for instructions on how to turn it ON/OFF.
- Install the new tailgate handle camera.
*NOTE: To power the camera, use RED Wire A or B. If tapping power from the radio or RVC Interface, make sure to insulate RED Wire A to avoid it from shorting. If you will be tapping power from the reverse light +12V, insulate RED Wire B to avoid it from shorting. With either connection the Black GROUND wire needs to be connected to a solid chassis ground. For vehicles with manual transmission, we recommend tapping +12V power from the reverse light.
GREEN Wire: Connect to show parking guide line. Cut loop to remove guide lines. Insulate with tape to avoid from shorting.
WHITE Wire: Not used, do not cut.
Note: Cycle the camera power after connecting or disconnecting the GREEN control wire.
VEHICLE APPLICATIONS:
NISSAN
2013 – 2016 Frontier
NOTE: Nissan emblem and key cylinder not included.