SAFETY & WARNINGS
Battery Warning
Do not disassemble, bore or damage the battery. Do not disassemble the built-in batteries of non-replaceable battery devices. Do not use sharp objects to remove the battery.
Health Warning
- If you are wearing a pacemaker or other implanted electronic devices, please consult your doctor before using the heart rate monitoring strap.
- The watch’s optical heart rate sensor glows green and If you suffer from epilepsy or are sensitive to blinking light sources, please consult your physician if you can wear this product.
- The device tracks your daily activities through These data are intended to tell you about your daily activities, such as steps, sleep, distance, heart rate and calories, but may not be completely accurate.
- The device, accessories, heart rate sensors and other relevant data are designed for entertainment and fitness, not for medical They are not applicable to the diagnosis, monitoring, treatment or prevention of any diseases or symptoms. The heart rate data is for reference only. It is not responsible for any consequences caused by any data deviation.
Cycling Warning
- Please always maintain good judgement and ride in a safe Make sure your bike and hardware are properly maintained and all components are properly installed.
Matters Needing Attention
- kogan-active-lite-smart-watch-user-manual
- Watch data needs to be kept once every 7 days to avoid data loss.
- The watch has no waterproof effect on seawater, acidic and alkaline solutions, chemical reagents and other corrosive The damage or defects caused by misuse or improper use are not covered by the warranty.
- Sports mode supports up to 6 hours of exercise at a Time.
- The watch has a waterproof level of SATM and supports cold water shower, swimming, but not driving.
- Avoid wearing the watch too tight in daily use. Please keep the parts of the watch touching the skin dry.
- When your heart rate is measured, keep your arm still during the test.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference and
- This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could avoid the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encourage cl to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
kogan-active-lite-smart-watch-user-manual
OVERVIEW
- Power on
The device will turn on automatically after charging.
Note: The device must be charged and activated before the first use. Always use the original power adaptor to charge the device. - Download and install VeryFitPro
Hardware requirements by platform are shown below:
- Connect via Bluetooth
- Device Pairing
Drop down on the opp’s home screen to show the pairing request. Select the product model and top “Confirm Binding” to pair.
Notes
- On iOS only, proceed to the phone’s regular Bluetooth settings and search and pair to the watch.
- During pairing, VeryFitPro will prompt you to enable GPS and Bluetooth and authorise VeryFitPro to get access to the GPS on your mobile phone.
Syncing Data
The watch will collect various data during use. To sync data, connect the watch with Bluetooth and open the app: swipe down and the sync prompt will appear.
Notes
- Sync data at least once within 7 days to avoid data loss.
Fitting
Wear the device a finger’s distance from the wrist and adjust the tightness of the wristband to a comfortable position.
Note: Wearing too loosely may affect the accuracy of heart rate data.
Strap replacement
Flip the switch and to remove the strap for replacement.
OPERATION
Button operation
Changing watch interface
Main interface
Swipe on the screen to enter the relevant interface.
Icon functions
Note:
For more functions (sleeping) and operation, please check the VeryFitPro software of the mobile phone. Try to ensure that the box fits appropriately.
Sport mode
To record sport activity:
- Click the sports icon and select activity type and the countdown timer will begin.
- Press the right button to pause/resume timer.
- Press and hold the right button to stop the timer and press the end button to exit sport mode.
Women’s health tracking
Used for recording menstrual changes, tracks individual menstrual cycle and predicts ovulation.
This function must be enabled on the app.
CLEANING & CARE
To ensure product function, the following points should be observed:
- Keep the watch clean and dry.
- Do not wear the watch too tightly.
- Do not use household cleaners to clean the watch; instead, use a soap-free detergent.
- Alcohol can be used to scrub stains that are not easy to remove.
TROUBLESHOOTING
Cannot locate watch in app search
- Update VeryFitPro to the latest version.
- Close all programs, disconnect and reconnect Bluetooth.
- Confirm operating system is Android 4.4 / iOS 8.0 or above.
Notification/text/phone call not received
- Enable smart reminder function/call reminder switch in app and synchronise to watch
- Ensure mobile device is paired via Bluetooth
Bluetooth disconnects
- Ensure distance is not greater than 7 metres
- Ensure there are no obstructions — note that metal jewellery, can interfere with Bluetooth signal
- Ensure mobile phone’s Bluetooth function is working
Kogan-active-lite-smart-watch-user-manual
FAQ &Tips
Data backup
- Synchronise data at least once per 7 days as the watch returns data for 7 days.
Factory reset
- Pair watch through the app and reset though Device Model > More Settings
Do I need to keep my Bluetooth on when I wear my watch?
- For the pedometer, sleeping and alarm clock functions, a Bluetooth connection is not required and you can sync data later.
- For the call alert, message alert and find my phone functions, Bluetooth must be connected.
For further troubleshooting steps, see the Help and Feedback setup in section within the app.
Disposal
Kogan-active-lite-smart-watch-user-manual