User Guide of Applied Motion Products MSSM23 Q/IP Ethernet Integrated Motor
Requirements
To begin, make sure you have the following equipment:
- A small flat blade screwdriver for tightening the connectors (included).
- A 12-70V DC power supply.
- A personal computer running Microsoft Windows XP, Vista, 7, 8 or 10 (32 or 64 bit).
- Step-Servo Quick Tuner software (available at www.applied-motion.com/products/software).
- A CAT5 network cable (not included).
- For more detailed information, please download and read the appropriate hardware manual, available at
www.appliedmotion.com/support/manuals.
Step1
a) Download and install the Step-Servo Quick Tuner software.
b) If you intend to connect the drive directly to your PC, configure your computer to use IP address 10.10.10.11. (For instructions on connecting your SSM drive to a local area network (LAN), please consult the appropriate hardware manual)
c) On the SSM drive, select switch position 0, which will assign IP address 10.10.10.10. (See the hardware manual for further details on selecting IP addresses for the drive and PC)
d) Launch the software by clicking: Start / All Programs / Applied Motion Products / Step-Servo Quick Tuner
Step2
Wire the drive to the DC power source.
(Do not apply power until Step 3)
Note – the SSM drive accepts DC voltages from 12-70V. If using an external fuse, we recommend a 4 amp fast acting fuse .
(See the appropriate hardware manual for more information about power supply and fuse selection.)
Connect I/O, if required by your application. (See the appropriate hardware manual for more information about wiring I/O to the SSM drive.)
Step3
a) Apply power to the drive. The drive model and firmware revision should be automatically displayed in the Step-Servo Quick Tuner software.
b) Follow the configuration instructions in the Step-Servo Quick Tuner help screens. The Step-Servo Quick Tuner software can be used to set up your drive to operate in several different modes including: pulse & direction, velocity (oscillator), streaming commands (SCL), and Q programming mode.
c) To test motion, use Jog buttons on Motion Simulation tab in Step-Servo Quick Tuner.
If you have any questions or comments, please call Applied Motion Products Customer Support: (800) 525-1609, or visit us online at applied-motion.com.
18645 Madrone Pkwy
Morgan Hill, CA 95037, USA
1-800-525-1609
applied-motion.com
SSM23 Q/IP Ethernet
Quick Setup Guide
920-0091C